Rubber Gaskets & Spacers

DIE-CUT & MOLDED
Rubber Gaskets & Spacers

Flat-face seals for flanges, pipe joints, covers and enclosures. Die-cut or molded to your drawing in NBR, EPDM, silicone or FKM — compensating for uneven mating surfaces while sealing out water, dust and process media.

  • Static flange and face sealing — pipe joints, pump and valve end faces
  • Die-cut for speed and economy, molded for complex profiles
  • NBR, EPDM, VMQ silicone, FKM — custom thickness and bolt patterns
  • Compressed face compensates slight unevenness of the joint surface
  • Elastic cushioning: shock absorption, anti-slip and electrical insulation in one part

PROCESS: Die-cut · Molded
SHAPES: Ring · Frame · Custom
MATERIALS: NBR · EPDM · VMQ · FKM
MADE TO: Drawing · Sample

Get a Free Quote

Material Selection Guide

Match the compound to your media — the wrong rubber in the wrong fluid is the most common gasket failure we see.

MaterialBest ForTemp. Range
NBR (Buna-N)Mineral oil, gasoline and hydraulic lines — the universal grade.-30°C to +100°C
EPDMWater, hot water, steam, antifreeze — water supply, drainage and HVAC.-50°C to +150°C
VMQ SiliconeFood and medical equipment, high-temperature air — sanitary grades.-60°C to +200°C
FKM (Viton®)Oil-resistant, reinforced, high-temperature and chemical service.-20°C to +200°C

Where It’s Used

One flat seal, hundreds of static joints.

Water Supply & Drainage

Pipe flanges and pump joints in municipal and building systems.

HVAC

Duct flanges, fan housings and equipment covers.

Automotive

Engine covers, sumps and fluid-system flanges.

Food Equipment

Sanitary-grade silicone gaskets for process lines.

Pumps & Valves

End-face sealing on valves, filters and pressure vessels.

Electrical Enclosures

Dust- and moisture-proofing for cabinets and chassis.

Gasket FAQ

Yes — flat gaskets seal clamped faces and are not suitable for reciprocating or rotating dynamic service. For motion, look at our O-rings, X-rings or hydraulic seals.
Die-cutting wins on tooling cost and lead time for flat profiles; molding wins for complex 3D shapes and very high volumes. We will quote both if you are unsure.
Under high pressure they can extrude — use a retaining ring or a composite gasket — and long high-temperature service causes compression set and hardening. They also need uniform bolt torque: uneven torque is a classic leak cause.
Cold water and steam → EPDM; engine and hydraulic oil → NBR; food contact and high-temperature air → VMQ silicone; strong solvents and high-temperature oil → FKM. Tell us the media and temperature and we will confirm.