Die-Cutting Parts
DIE-CUT PARTS
Die-Cutting Parts
Precision die-cut gaskets, washers, shims, insulators and seals — steel-rule cut from sheet and roll stock in rubber, sponge, cork and composites. Fast turnaround, economical at volume, with custom material selection, tool design and secondary services for automotive, aerospace and medical industries.
- Steel-rule die cutting for clean edges and tight repeatability
- Rubber sheet, sponge, cork, PTFE, non-asbestos and composites
- Gaskets, washers, shims, pads and insulators
- Custom material selection, tool design and secondary services
- Kiss-cut on rolls for peel-and-stick assembly
Stock Materials & Uses
Common stocks we cut from — custom materials on request.
| Material | Use |
|---|---|
| NBR / EPDM sheet | General gaskets and seals |
| Silicone sponge | Soft sealing, cushioning and thermal insulation |
| Cork-rubber | Oil-resistant flange gaskets |
| PTFE sheet | Chemical-resistant washers and liners |
| Non-asbestos sheet | High-temperature flange service |
Where It’s Used
Flat parts, everywhere.
Electronics
Insulators, pads and gaskets for devices and cabinets.
Automotive
Shims, washers and NVH pads across the vehicle.
Appliances
Sealing and cushioning inside housings.
HVAC
Gaskets and insulation pads for equipment.
Electrical Panels
Insulating and sealing die-cuts for switchgear.
Industrial Equipment
Machine shims, mounting pads and guards.
Die-Cutting FAQ
Send your part dimensions — we will confirm the most economical sheet layout and nesting.
Steel-rule cutting holds tight tolerances on flat profiles — share your drawing and we will confirm.
Yes — pressure-sensitive adhesive with release liner, kiss-cut for easy peel-and-place assembly.
Low tooling cost makes die-cutting ideal for prototypes and pre-production runs before mold investment.