MANUFACTURING · October 10, 2026 · Sanzhu Engineering Team

A custom rubber part starts as a drawing and ends as a molded, trimmed, inspected component ready to install. Between those two points sits a process most buyers never see — but understanding it helps you write better RFQs, avoid schedule surprises, and judge competing quotes sensibly. Here is the full path, step by step.

Step 1: RFQ review and moldability check

Everything starts with the drawing. Before quoting, a good supplier checks it for moldability: Are the draft angles sufficient for the part to release? Where should the parting line sit so flash lands on a non-sealing surface? Are there undercuts that need special tooling? Are the tolerances realistic for molded rubber? This review is where experienced suppliers earn their keep — flagging problems before tooling is cut saves weeks and real money. If you only have a sample part and no drawing, it can be measured and reverse-engineered into one.

Step 2: Mold tooling

The mold is machined from steel to the exact negative of your part, and it is usually the longest lead-time item in the project. Compression molds are the simplest and most economical — uncured rubber is placed in the cavity and the press closes. Transfer molds suit complex shapes with tighter tolerances. Injection molds cost more upfront but cycle faster with minimal flash, which pays off at higher volumes. What drives tooling cost is complexity — undercuts, inserts, multi-cavity layouts — more than part size.

A point buyers often miss: the mold is a one-time cost, but it defines your part forever. Cavity count is the main lever — a single-cavity mold is cheapest to cut but slowest to run, while a multi-cavity mold costs more upfront and drops the per-part price at volume. Discuss expected volumes before tooling is designed, not after, so the cavity layout matches your program.

Step 3: Compounding

Rubber compound is mixed to a recipe: base polymer, reinforcing fillers, curing agents, processing aids, and color. Hardness, temperature rating, fluid resistance, and aging behavior are all locked in at this stage — which is why "NBR 70 Shore A" from two suppliers can perform differently. Batch consistency in mixing is one of the quiet markers of a reliable molder, and it is exactly what material test reports verify.

Step 4: Molding and curing

Heat and pressure do the actual work: the press closes the mold, and curing (vulcanization) cross-links the rubber into its final shape and properties. Cure time depends on compound and section thickness — thick parts need longer cures so heat reaches the center, and rushing this step is a classic cause of soft cores and premature failure. Process control here is about repeatability: same temperature, same pressure, same time, every cycle.

It is also worth knowing what can go wrong at this stage. Under-cured parts feel soft and take a permanent set quickly; over-cured parts turn brittle and crack. Porosity — tiny voids inside the part — usually traces back to trapped air or moisture in the compound. A molder with disciplined process control catches these before they ship, which is why asking about in-process checks matters more than asking about the press brand.

Step 5: Trimming, inspection, and packing

Fresh from the mold, parts carry thin flash along the parting line. Flash is trimmed — by hand, cryogenically, or in tumbling — then parts go through dimensional checks against the drawing and visual inspection. Critical dimensions are measured per batch, and material or dimensional test reports are available on request. Only then are parts counted, bagged, and packed for shipment.

Molding methodHow it worksBest for
CompressionRubber placed in open mold, press closesSimple parts, low to medium volumes, lowest tooling cost
TransferRubber forced through channels into closed moldComplex shapes, bonded inserts, tighter tolerances
InjectionRubber injected under pressure into closed moldHigh volumes, minimal flash, fast cycles

Knowing these five steps also tells you what to ask any molder: how they review drawings, what their tooling lead time is, how they control compound consistency, and what inspection comes standard. The answers reveal more than the price does.


← Back to Blog  |  Send an Inquiry